Andersons Restorations

  Here are the finished seats and accessories. There is a set for a Jolly, a 500 and a Schellette with a dashboard, door pulls and a center...

 Just dropped off is 4 sets of seats. 1 set is for a Fiat Jolly, 1 set is for a Fiat Schellette 1 is for a Fiat 500 and the 2 in red are ou...

This is the finished Douchesse set put together. We have done the 3 bottoms and one panel in the back, Blind Cane, plus a few small repa...

Here's the back of the chair during weaving in the Blind Cane.

This is a Douchesse set that needs the seats and footstool done in regular hand cane and one section if the larger piece done with Blind c...

These 4 chairs have been used by the owner to play cards with the ladies for many years. Now recaned, the should last the ladies many mo...

 These are 19 frames from a 1936 Ford School Bus that the customer bought to convert into a food truck! The frame were nickel plated but t...

Here is a childs rocker that the back is broken and what's left is very brittle. The customers have a picture of their 98 year old mot...

Here is the rocker with a new back ready to paint. When they picked it up, they were heading back to the NC coast but were going to stop a...

Here is a brass clock that the customer never remembered not being green on the mantel.After taking it apart, we cleaned all the parts, po...

Here is a Mahogany chair that has seen better times. As with a lot of furniture, it has been transformed from a cane chair to an upholste...

Here is the finished chair with all the material and glued padding gone. Refinished and recaned.

 The dog left the homework alone but not so much the chair. Plastic wicker, discontinued model. Customer said to replace this one chair wo...

Another dog gone bad. Chewed on both sides of this arm. We repaired then had to color to match. Currently, there is not a lot of choices o...

This swing has seen some damage from rain over the years. We braced the bottom,added new seat parts, braid and the front roll and new war...

This chair was a family piece and was restored for the new grandchild to use. We made the new pieces and later put in a new pressed cane s...

This set of seats was modified to convert the car to a Fiat Jolly. They are slightly different then the factory seats but I don't thin...

Here is the rear set of seats for the Fiat Jolly.

This riser is for a two wheel cart. It attaches to the bed of the cart and the seat attaches to the top. It's sitting as you would see...

This is a frame for a mid century "chrome" chair. The customer bought it on line somewhere and took the frame to be re-chromed t...

Here is the chair done and ready for finish. Used round reed for this project.

This is a McGuire chair, one of a set. The seat had broken so we installed a new pressed cane seat and stained to match.

Here is a close-up of the new braid on the table. We used binder cane and painted to match.

Here we have a nice wicker table that jus needed some TLC. The edge detail as the most damage so we elented to replace it all.

Here is a mid century "Danish" modern chair, one of two. We replaced the back using wide binder cane like it was.

Here is a pressed cane chair with the cane in 3 sections. The top and bottom groove are one for the whole chair and the middle and side piec...

You just can't find good help anymore.

Here is the newest chair caner to the team, my Great Grandson Ian, born 9/30/2011 at 8 lbs 14 oz. The future looks bright.

Here are the Fiat seats ready to put in the crate for shipping. We stained just a little to take off the "new" of the reed and coa...